Lamella Settler™

Well proven lamella sedimentation technology. Stainless tank with inclined plastic plates that can be removed individually for cleaning or replacement.

The Lamella Settler™ comprises a stainless tank in which individual plastic plates are supported and inclined at the optimum angle of 60°. Two different models are available with either a 50 mm or 80 mm gap between the plates and the choice of model depends on the application. The capacity depends on the settling velocity of the particles to be removed. The size of the sludge collection hopper is maximised in the KWI design to allow sludge thickening by compression and reduce the length of the time the sludge discharge pump needs to run.

KWI Lamella Settler™ is available in 10 sizes for flows from 5 to 220 m3/hr.

Applications

  • Suitable for all applications where sedimentation is the preferred technology.

Product Advantages

  • Lower capital cost than conventional settlement clarifiers.
  • Smaller foot print than conventional settlement clarifiers.
  • Stainless tank delivered in one piece to reduce site construction time.
  • Can be supplied with integral flocculation tank & mixer.
  • Large solids hopper to increase sludge consistency by compaction.
lamella settler™
Type Projected lamella area A (mm) B (mm) C (mm) Weight tons
(full of water)
LS5 13,6 3250 3780 1400 4,7
LS5 26 3900 4150 1400 8,4
LS5 40 4450 4150 1350 11,9
LS5 52 3885 4150 2480 14,8
LS5 68 4360 4350 2480 19,2
LS5 86 4950 4700 2480 25,6
LS8 6,8 3250 3780 1400 4,8
LS8 13,6 4000 3780 1400 8,7
LS8 20,4 4450 4150 1350 11,9
LS8 27,2 3980 4150 2480 15,3
LS8 40,8 4700 4400 2480 22,1